|
| I converted my pull type Fast 9613N to John Deere Greenstar rate controller I have all necessary cabling. I have everything setup in main setup screen for 3 wire valve and standard control valve. Everything shows up on display. I had it working for a short time and now I can not get it to open valves or communicate with the Raven system. I go into main Controller screen and tap on manual and it will show up as green bars and then get the message no flow detected, pump is dry. Foot switch turns master switch on and off, but can't get any solution to come out of nozzles. Thanks for any help. | |
|
Greenstar Rate Controller Raven Question
