|
NWKS | I will be going thru it alittle more today. As far as I can tell everything is in decent, servicable condition. The gauge wheels are adjusted all the way up with essentially no more upward travel.
Its a tricky thing, if I put a cylinder spacer in the main lift cylinders, I can get another 2" of clearance, however the center section is out of the ground then. I just don't see any way this thing will drill without rubbing those gauge wheels.
Dealership has absolutely no ideas.
Edited by MattKS 9/19/2024 17:25
 (62ECB994-0B4E-4610-8A8B-24553F332AD1 (full).jpeg)
Attachments
----------------
 62ECB994-0B4E-4610-8A8B-24553F332AD1 (full).jpeg (185KB - 1 downloads)
| |
|
Sunflower 9433 drill...tires rubbing
