|
Central PA | tedbear,
i dont need a pullup resistor...i measured the sensor voltage into the flow meter input and it is switching +14' , 0 v. so i know the prox sensor is sending pulse to the module. this is very low frequency, like 1-2 Hz as it is off the apron chain, 1 bolt pass per revolution on the shaft. is there a hpf that limits this low freq pulse? not much info out there on the app rate module.
the setup options show the implement switch choice but no flow sensor option. i do use the switch input for other operations with a wisker switch on the 3pt.
i did setup a configuration for this implement (bbi spreader). i did not select anything for cotroller as this is only to monitor delivery rate. i realize i will need to figure out an appropriate cal number.
the options for direct command obviously doesnt fit the app rate module.
it seems i am on the wrong trail in the incommand setup menus. some sequential pics may help. | |
|
AL- help, How do you setup app rate module with flow meter input
